If you have a car featuring 4l60e transmission, then you know that how smooth and powerful your car is. Your car’s speed and outlook are enough to impress your friends and family. However you have to take care of your car regularly to keep your car in condition. If you are driving such a beautiful and powerful car, you suppose to know little technical part of your car so that you can take care of it properly. Before you do the servicing part, you have to know how to remove 4l60e from the system.
How to remove 4l60e?
You as a proud owner of a car that featured 4L60E Transmission should know that your car is a machine and regular maintenance will make it free from major technical problems. There are parts that wear down and proper care and replacement is needed during the years. Removal of the transmission is expensive and if you know how to remove transmission you can save plenty of cash for yourself. Whether you have a little bit of technical knowledge or you are completely inexperienced, these tips will help you to do the job professionally.
Before you start the proceeding to remove the transmission, you have to disconnect the cable that is negative from the battery. You can use a socket and ratchet to take away the cable. Once you have done that, you can go on to the next step.
Raising the vehicle:
Once you have disconnected the battery, next is to raise the car. You can use a jack to raise the car off the level. Then place the suspension and the jack on the right place underneath the car. Since the front tires are in the air, place a block in the back tires so that the car doesn’t roll off. Once the car is set, take out all the 4L60E Transmission fluid. Then slightly remove the side and front bolts and loose the bolts in the back. Then drain entire fluid off the pan.
Removing the filter and pan:
The next step is to remove the filter and drain pan. Then you can disconnect all the three wires from the starter motor. Remove the bolts to remove the motor. Then you can remove washers, nuts and straps off the pinion flange.
Then you can unplug speed sensor to remove it and then flat washer and bolt. After that remove all the cable off the transmission. Once all the nuts of the transmission are off, this is the time to pull off the transmission. Before that remove the dipstick tube of the transmission. Before pulling out the transmission, make sure that the torque converter is detached the its position.
Once the 4l60e transmission is out, you can inspect it to repair it. If you think that the car need a new transmission then you can purchase it from the market. You can go online to purchase a transmission at an affordable price. Regular maintenance of transmission will ensure that your car runs smoothly and perfectly.